Then you get to route the window defroster wire through the soft top sleeve and stuff but that's way too hard to explain without pics.

Run the seatbelt through the new plastic trim, install the reused plastic plugs into the trim and snap it into place.

Mine came with 2 sets of bolts for the bottom hole, it didn't seem to matter which I used but I thought that was weird. Green 2zz, Red 2zz, veilside turbo (sold), monocraft wide body (sold) Lotus Elise. For track you need a proper rollbar firat.

Install the mounting posts using the supplied bolts. 15x9 wheels 225/15 front 245/15 rear R-comp tires.

The HT should have come with 2 new trim parts with sections of them cut out to accommodate the hard top mounting posts.

Remove the left and right plastic trim parts that the seat belt passes through (unbolt the seatbelt base).

If I turned far enough my hand would hit my legs while holding the wheel and I could turn no further without shuffling the wheel. Most Popular Accessories & Parts for 4Runner Toyota TRD 4Runner Matte Black 6-Lug Wheel 17x7 4mm Offset (10 (6) TRD Style Matte Black 6-Lug Wheel 17x8. At 61' the stock wheel in its highest position would almost tough both of my legs. Appearance Modifications Hardtop metal brackets.

Replace them with the stainless latch parts Both of my cars run a 300mm steering wheel and I could never go back to the stock diameter wheel.

Remove the rear tabs near the engine hinge that are body colored painted on the Left and Right side.

but if no one posts up I can send you a scan of the install info via PM on Sunday. It was a few years ago so I don't remember the actual instructions.

Those things above aren't in any instructions but two things I noticed I messed up on the first hard top install. I agree with Dev though, spacers will put more stress on the wheel bearings, as it effectively acts as a lever to amplify the weight of the wheel. Did it come with all mounting hardware and modified plastic trim pieces?Ģ things on that - when you pull the seatbelts through the old trim pieces, be careful not to pop the retaining rivet off of the seatbelt when you pull it through the plastic trim that is being replaced.Īlso, when installing the new plastic trim using the plastic rivet(s) that holds it in place, do not push too hard otherwise you will 'crease' the trim and create a white mark from pushing to hard (like when you fold a credit card in half, you get that white stress line from bending plastic). I also didnt run them long enough to wear out a wheel bearing prematurely though, and made sure my lugnuts were torqued after installing and driving about 100 miles.

Mr2 spyder 17 wheels mr2 spyder hardtop